Glass in windows isn’t just for looks, it helps protect your home from the elements. In addition, the right specialist glass for each room of your house can optimise energy efficiency, provide privacy and even increase safety in certain situations.
When a window pane breaks, it can be dangerous for small children or pets, and it also compromises the security of your home. Fortunately, replacing a broken pane is relatively simple. In fact, most home improvement centers cut glass to order and can replace an existing window without removing the surrounding frame. If you’re not comfortable doing this yourself, we suggest contacting a local professional to ensure that the job is done correctly and safely.
To begin, make sure you’re wearing thick gloves and safety eyewear before you start working with any glass. Then, tape an asterisk-shaped pattern over the cracked pane to prevent any glass shards from falling out as you work. You can also use a sheet of duct tape to create a barrier around the area in case any glass chips fall. Finally, it’s a good idea to use a ladder stabilizer to reduce the risk of falls and injuries while working on second-story windows.
Using a utility knife, scrape away any residual glazing compound from the interior of the sash frame. Then, if necessary, remove any wood molding that’s securing the old pane with a flat pry bar. Next, use a wire brush to loosen any paint or dirt from the smaller crevices of the sash frames. If the frame is wood, sand it down to bare wood before applying new linseed oil-based caulking.
Once the frame has been cleaned, it’s time to prepare for the installation of the new pane. If you’re installing a new glass pane, measure the height and width of the opening as well as the thickness of the old pane. Record these measurements to help ensure that the replacement pane is a perfect fit.
You should also note that each pane has a vinyl stop around the edges that holds it in place. You’ll need to remove this before placing the new pane, so be careful not to damage it.
Roll a cord of glazier’s putty and press it into the frame where the glass will rest, making sure there is a thin bed of putty for the glass to sit on. If you’re installing a new insulated glass pane, consider putting glazier points every six inches, to add extra support and keep the pane in place.
Use your putty knife to smooth the compound, matching it as closely as possible with the other joints on the frame. Once the putty is dry, apply a coat of clear linseed oil to the surface. Then, wipe off any excess oil with a soft cloth or towel. After a few minutes, you can enjoy your restored window and the added energy savings that come with it. Be sure to check with your local building codes before repairing or replacing window glass, as there may be special regulations for sash windows that aren’t meeting current safety and energy standards.
source https://glassrepairlogan.wordpress.com/2023/10/03/how-to-do-a-glass-replacement/
No comments:
Post a Comment